- REMOVE FAN AND GENERATOR V-BELT
- Loosen bolts A and B.
- Release the V-ribbed belt tension and remove the V-ribbed belt.
- REMOVE RF WHEEL AND REMOVE ENGINE UNDER COVER RH
- REMOVE VANE PUMP V-BELT
- Loosen bolts A and B.
- Release the V-ribbed belt tension, and remove the V-ribbed belt.
- INSTALL VANE PUMP V-BELT
- Temporarily install the V-ribbed belt on each pulley.
- INSTALL FAN AND GENERATOR V-BELT
- Temporarily install the V-ribbed belt on each pulley.
- ADJUST FAN AND GENERATOR V-BELT
- Insert the adjusting bar between the engine RH mount bracket and generator. Push the bar towards the vehicle front to adjust the V-ribbed belt tension. NOTICE: Do not insert the bar between the oil control valve and generator. It could damage the oil control valve.
TIP: IF YOUR THE DRIVE BELT SQUEALS AND/OR VIBRATES. IT IS TOO LOSE. TIGHTEN BUT NOT TOO TIGHT.
No comments:
Post a Comment