DIY How to replace install spark plugs 2001 Jeep Cherokee

DIY How to replace install spark plugs 2001 Jeep Cherokee

1997 1998 1999 2000 2001 Jeep Cherokee, L6 4.0L

Labor Time: 1.0

P0440 P0442 DIY How to replace install overfill check valve 2000 Toyota Camry

DIY How to automatic transmission flush 2001 Toyota 4Runner

How to check transmission fluid level 2013 Ford Mustang V6

If the installation of a new transmission fluid cooler or transmission fluid cooler tubes has been carried out, the vehicle must be driven to get the transmission fluid to a temperature of 88°C (190°F) in order to purge the air from the transmission fluid cooling system.

1. With the engine running, place the transmission selector lever in each gear position and hold approximately 5 seconds. Place the transmission selector lever in PARK.
2. With the engine idling (600-750 rpm) in PARK, position it on a hoist.
3. Remove the transmission fluid fill plug and transmission fluid level indicator assembly, located on the passenger side front portion of the transmission case.

4. Separate the transmission fluid level indicator from the transmission fluid fill plug.

5. Wipe the transmission fluid level indicator clean. Reinstall only the transmission fluid level indicator back into the transmission fluid fill plug hole to check the transmission fluid level.

6. The transmission fluid level indicator has 2 areas for the fluid level, a crosshatched (labeled A) area and a dotted (labeled B) area. Use the crosshatched area when checking the transmission fluid level. The correct transmission fluid level is at the upper level of the crosshatch marks on the transmission fluid level indicator.

Using the scan tool, verify that the Transmission Fluid Temperature (TFT) is between 80°C-85°C (176°F-185°F). Do not overfill the transmission. The transmission fluid level must be at the upper level of the crosshatch mark.

7. If the transmission fluid is not at the correct level, follow the steps for Adding Additional Transmission Fluid or Removing Transmission Fluid. Install the transmission fluid fill plug.

• Tighten to 35 Nm (26 lb-ft).

Bank 2 Sensor 1 location, 2000 Solara V6 engine

Location of AIR DOOR actuator 1997-2002 Toyota Camry

If you wanted to remove the air door actuator. It is located on the driver side, look way on top of gas pedal.

1. Release the claw and pull out the plate.

b. Remove levers on pins

c. Disconnect the connector.

d. Remove the 3 screws and servomotor

How to test Intake Air Flow Meter/Mass Air Flow Sensor (MAF) 2003-2008 Toyota Matrix Corolla

a.Check the operation.

1.Apply battery voltage across terminals 1 (+B) and 2 (E2G).
2.Using a voltmeter, connect the positive (+) tester prove to terminal 3 (VG) and the negative (-) tester prove to terminal 2 (E2G).
3.Blow air into the mass air flow meter, then check that the voltage fluctuates. If the voltage does not fluctuate, replace the mass air flow meter.

2. Check the resistance.   
3. Using an ohmmeter, measure the resistance between the terminals.

Standard:

If the result is not as specified, replace the mass air flow meter.