2007-2009 Suzuki XL7 Spark Plug gap and labor

2007 2008 2009 Suzuki XL7 Spark Plug gap and labor

GAP 0.043" Labor 1.2 hours

Removing driver side door panel 1993-97 Honda Accord

1993 1994 1995 1996 1997 Honda Accord

Labor Time: 0.3

DIY How to replace install combination headlamp turn signal switch 1997 Honda Accord

DIY How to replace install combination headlamp turn signal switch 1997 Honda Accord

1993 1994 1995 1996 1997 Honda Accord

Labor Time: 0.4

DIY How to replace remove install starter motor 1997-2003 Toyota Camry

1997 1998 1999 2000 2001 2002 2003 Toyota Camry, 2.2L

Labor Time: 1.0

2003-2009 Toyota Prius L4-1.5L (1NZ-FXE) Hybrid [OIL TYPE & CAPACITY]

2003 2004 2005 2006 2006 2008 2009 Toyota Prius L4-1.5L (1NZ-FXE) Hybrid

Engine Oil Capacity (drain and refill)
                                 With new filter:  3.7 Liter/ 3.9 Quarts 

Engine Oil Type:  SAE 5W-30

2003-2014 Toyota 4Runner Tacoma 2WD 4WD V6-4.0L (1GR-FE) DRIVEBELT

2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014

Toyota 4Runner Tacoma 2WD 4WD V6-4.0L (1GR-FE) DRIVEBELT Drive belt

Labor Time: 0.5

1986-1993 Volvo 240 L4-2.3L SOHC VIN 88 B230F OIL TYPE & CAPACITY

1986 1987 1988 1989 1990 1991 1992 1993 Volvo 240 L4-2.3L SOHC VIN 88 B230F

CAPACITY, Refill:

4-cyl. 2.3L, SOHC	3.4 liters (3.6 quarts)
4-cyl. 2.3L, DOHC	3.5 liters (3.7 quarts)
6-cyl, 2.4L Diesel	5.0 liters (5.3 quarts)
V6 2.8L	5.5 liters (5.8 quarts)

Capacity shown is without filter. When replacing filter, additional oil may be needed. On models with oil cooler, additional oil may be needed if cooler is drained.

OIL TYPE:

1991	SG, SG/CD(Motor Oil, API Service SG/CD)
1986 Diesel engine	CD, SF/CD(Motor Oil, API Service SF/CD)
1986-90 Gasoline engine	SF/CD, SG; SF, SF/CC

Diesel Engines:

Above 0°F (-18°C)	15W-40
-13°to 68°F (-25°to 20°C)	10W-30
Below 68°F (20°C)	5W-30

Gasoline engine

Above 0°F (-18°C)	15W-40
-4°to 104°F (-20°to 40°C)	10W-30
Below 68°F (20°C)	5W-30

2012 Dodge or Ram Truck RAM 1500 2WD V8-5.7L

Engine Oil with Filter                      6.6 Liters (7.0 Qt) 5.7L Engine                                      SAE 5W-20, API Certified 5.7L Engine*                                    SAE 5W-30, API Certified* For 2500/3500 trucks operating under a gross combined weight rating greater than 14,000 lbs (6,350 kg).

Timing Belt Labor Time: 2003-2006 Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo

2003 2004 2005 2006  Mitsubishi Lancer Evolution L4-2.0L DOHC Turbo


Timing Belt                                       3.0 hours


To R&R Manual Tensioner, Add        0.1
To R&R Idler Pulley, Add                   0.1
To R&R Tensioner Pulley, Add           0.1
To R&R Auto Tensioner, Add             0.1
To R&R Water Pump, Add                 0.8

2005-2010 Ford Explorer V6 4.0L Drive Belt Diagram

2005 2005 2006 2008 2009 2010 Ford Explorer V6 4.0L Drive Belt Diagram

Labor Time: 0.3

Chevy Malibu EASY follow front brake pads rotors REPLACEMENT√

Chevy Malibu EASY follow front brake pads rotors REPLACEMENT√

2004 2005 2006 2007 Chevy Malibu LT V6

Labor Time: 1.5

DIY How to replace install front brake pads rotors 2009 Mazda 6

DIY How to replace install front brake pads rotors 2009 Mazda 6

2007 2008 2009 2010 2011 2012 Mazda 6

Labor Time: 1.5

DIY How to replace remove install starter motor 1998 Toyota Corolla

DIY How diagnose replace install catalytic converter 2001 Honda Odyssey

DIY How diagnose replace install catalytic converter 2001 Honda Odyssey

1998 1999 2000 2001 2002 2003 2004 Honday Odyssey, V6, 3.5L

Labor Time: 1.0

DIY How to automatic transmission flush 2003 Honda Odyssey

Keys lost?? How to remove aftermarket gas fuel cap in 10 seconds

DIY How to replace install front brake pads rotors 2000 Ford Focus LX

2003-2009 Toyota 4Runner V6, PROBLEM SYMPTOMS TABLE FOR AIR CONDITIONING

DIY How to replace install front passenger window regulator motor 2004 Honda Pilot

How to test A/F Air Fuel Ratio Sensor 2000-2007 Toyota Highlander V6

INSPECT HEATER RESISTANCE OF A/F SENSORS 

1. Disconnect the A/F sensor connector.
2. Using an ohmmeter, measure the resistance between the terminals +B and HT.

Resistance:
0.8 - 1.4 ohms at 20 °C (68 °F)
1.8 - 3.2 ohms at 800 °C (1,472 °F)

If the resistance is not as specified, replace the sensor.

DIY How to diagnose replace blower motor resistor 2004 Chevy Suburban

DIY How to replace install spark plugs 2001 Jeep Cherokee

DIY How to replace install spark plugs 2001 Jeep Cherokee

1997 1998 1999 2000 2001 Jeep Cherokee, L6 4.0L

Labor Time: 1.0

P0440 P0442 DIY How to replace install overfill check valve 2000 Toyota Camry

DIY How to automatic transmission flush 2001 Toyota 4Runner

How to check transmission fluid level 2013 Ford Mustang V6

If the installation of a new transmission fluid cooler or transmission fluid cooler tubes has been carried out, the vehicle must be driven to get the transmission fluid to a temperature of 88°C (190°F) in order to purge the air from the transmission fluid cooling system.

1. With the engine running, place the transmission selector lever in each gear position and hold approximately 5 seconds. Place the transmission selector lever in PARK.
2. With the engine idling (600-750 rpm) in PARK, position it on a hoist.
3. Remove the transmission fluid fill plug and transmission fluid level indicator assembly, located on the passenger side front portion of the transmission case.

4. Separate the transmission fluid level indicator from the transmission fluid fill plug.

5. Wipe the transmission fluid level indicator clean. Reinstall only the transmission fluid level indicator back into the transmission fluid fill plug hole to check the transmission fluid level.

6. The transmission fluid level indicator has 2 areas for the fluid level, a crosshatched (labeled A) area and a dotted (labeled B) area. Use the crosshatched area when checking the transmission fluid level. The correct transmission fluid level is at the upper level of the crosshatch marks on the transmission fluid level indicator.

Using the scan tool, verify that the Transmission Fluid Temperature (TFT) is between 80°C-85°C (176°F-185°F). Do not overfill the transmission. The transmission fluid level must be at the upper level of the crosshatch mark.

7. If the transmission fluid is not at the correct level, follow the steps for Adding Additional Transmission Fluid or Removing Transmission Fluid. Install the transmission fluid fill plug.

• Tighten to 35 Nm (26 lb-ft).

Bank 2 Sensor 1 location, 2000 Solara V6 engine

Location of AIR DOOR actuator 1997-2002 Toyota Camry

If you wanted to remove the air door actuator. It is located on the driver side, look way on top of gas pedal.

1. Release the claw and pull out the plate.

b. Remove levers on pins

c. Disconnect the connector.

d. Remove the 3 screws and servomotor